I have a Trimble GeoXT handheld mapping GPS...and its internal GPS receiver has an external antenna hookup. Inside the case, a small length of coax plugs into a micro coax connector soldered to the board.

This coax connector has broken its solder joints completely and is no longer on the board. The design of the connector is such that it's impossible for me to solder it, as the center conductor is surrounded by four ground solder points (picture the center square in a tic-tac-toe grid).

Is there any kind of conductive adhesive that can be applied to the connector prior to placing it back on the board? It's damn tiny...about 2mm in size.

6/21/2006 2:02:45 PM