toyotafj40s All American 8649 Posts user info edit post |
thanks in advance for babycam79 for pickin my stinky ass up after i had to push my bike a couple blocks up hill and coming that far to pickup a shitty acc. book.
k so I'm cruising along and the bike cuts out, i pull the clutch in let it back out it fires right back up but then cuts out again.
i checked the fuses all good. has gas, and battery has full power.
it will fire for about 1/2 a second then cut out, and the engine doesnt sound abnormal for the 1/2 second it WILL fire up. i can rev it for that half second and it will cut out.
ie if i start it with the throttle on it will rev up to maybe only 6k? but before the revs have a chance to even drop it will cut out.
i noticed i don't get the fuel pump prime/whine like i usually get when turning the key and getting ready to start it.
i checked the one wire that runs to the fuel pump/gas tank and it was running 11.2 volts or whatever, when the key is in the on position. so it's definitely getting power.
I'm going with bad fuel pump. sound like a good guess?
do they just shit the bed like this? randomly?
does it make sense to have a bad fuel pump since it will only fire intermittently. what else could cause the fuel pump to cut out like this?
the bank sensor isnt it. bc when those go the bike wont start at all.
i thought i bought a honda and they dont break haha oops.
[Edited on January 10, 2008 at 10:22 PM. Reason : .] 1/10/2008 10:18:32 PM |
tripleD4u All American 6247 Posts user info edit post |
what bike is this?
[Edited on January 10, 2008 at 10:29 PM. Reason : l] 1/10/2008 10:28:11 PM |
toyotafj40s All American 8649 Posts user info edit post |
03 f4i 1/10/2008 10:47:10 PM |
P Nis All American 2614 Posts user info edit post |
I haven't been on here in a while, how many bikes did i miss since that rigged up suzuki? 1/10/2008 10:55:56 PM |
toyotafj40s All American 8649 Posts user info edit post |
just this one.
this is bike number 8
[Edited on January 10, 2008 at 10:56 PM. Reason : .] 1/10/2008 10:56:27 PM |
tripleD4u All American 6247 Posts user info edit post |
It sounds like it is a fuel issue. Pull the filter off and fire it off with a can of starting fluid if it runs then start tracing
[Edited on January 10, 2008 at 11:05 PM. Reason : prolly your pump on a real note tho] 1/10/2008 11:03:03 PM |
toyotafj40s All American 8649 Posts user info edit post |
word will do. as soon as i get it outta the damn parking lot locked to a poll right now. with a 'broke ass piece of shit, will get real soon' note on it.
im sure it will fire with starting fluid tho. it just seems like the fuel cuts and the bitch shuts off. bc it starts normally like it always would and runs just fine from the 1/2 of rpms i can hear.
[Edited on January 10, 2008 at 11:07 PM. Reason : .] 1/10/2008 11:07:17 PM |
tripleD4u All American 6247 Posts user info edit post |
There is only one thing to do in this case. Tube hooked up to some SF run it into your airbox hold that bitch wide open and do the same with some duct tape to the can of SF
[Edited on January 10, 2008 at 11:14 PM. Reason : gd] 1/10/2008 11:10:56 PM |
toyotafj40s All American 8649 Posts user info edit post |
i just filled this tank up with gas too . 1/10/2008 11:15:48 PM |
tripleD4u All American 6247 Posts user info edit post |
This just happen out of the blue then right? if you got power to the pump it prolly time for a new one
[Edited on January 10, 2008 at 11:20 PM. Reason : pbr] 1/10/2008 11:19:38 PM |
toyotafj40s All American 8649 Posts user info edit post |
yep power to the pump. time for a new one ...
priced them out at 65 shipped..
bullshit tho.. bike only has 10k miles. 1/10/2008 11:34:11 PM |
toyotafj40s All American 8649 Posts user info edit post |
also thanks for the advice. 1/10/2008 11:40:56 PM |
tripleD4u All American 6247 Posts user info edit post |
10k RLY Man that does not seem right at all!
[Edited on January 10, 2008 at 11:43 PM. Reason : this is not that one race f4i bike it was CL was it?] 1/10/2008 11:42:37 PM |
toyotafj40s All American 8649 Posts user info edit post |
nah it was one of the stunt ones that was on there. so it's had plenty of lot time that makes up for the low miles
also... i accidentally thumbed the starter when the bike was in 2nd gear. besides it lurching forward (was cabled around a pole) and stalling... this also caused it to have the fuel pump prime the next try... so i rode it home. HAH.
now to go wire tracing or fuel pump shopping
i hear sometimes tapping on bad fuel pumps helps them out kinda like tapping on a starter? maybe me starting it while it was tied around the pole did the same. haha. 1/11/2008 12:48:46 AM |
tripleD4u All American 6247 Posts user info edit post |
w0w 1/11/2008 12:55:45 AM |
BigBlueRam All American 16852 Posts user info edit post |
yeah, a well placed whack to a fuel tank or pump will get a pump going again in some cases. off hand, it sounds like it might be the pump from a couple of things you said. it could also be something ignition related though...
i would also be a little suspect of that voltage reading. some will have that much drop over the run, but ideally it should be closer to 12v unless you'd been cranking on it for a while. 1/11/2008 1:34:39 AM |
gk2004 All American 6237 Posts user info edit post |
Almost sounds like a coil. 1/11/2008 12:01:08 PM |
toyotafj40s All American 8649 Posts user info edit post |
^^ i was cranking it for a while. so it def. dropped the volage.
would a bad coil cause the fuel pump to not prime?
im going to check in the wiring harness this weekend for a fried wire as taht might be the case.
regardless i rode it to class/work today without a problem. 1/11/2008 1:03:59 PM |
graz All American 1834 Posts user info edit post |
it was 11.77V not 11.2V going to the fuel pump. 1/11/2008 2:43:47 PM |
toyotafj40s All American 8649 Posts user info edit post |
^oops. ty for the tools 1/11/2008 2:50:01 PM |
graz All American 1834 Posts user info edit post |
lol np. 1/11/2008 2:52:52 PM |
moparnum5 All American 705 Posts user info edit post |
just a guess, but my rr did that when the ground for the harness was loose 1/11/2008 4:07:57 PM |
toyotafj40s All American 8649 Posts user info edit post |
it did the same exact thing?
if the ground for the harness was bad, im Assuming i wouldnt be getting power to the pump at all. 1/11/2008 4:41:37 PM |
moparnum5 All American 705 Posts user info edit post |
well, it was loose, so it would sometimes work, then just die out. it's worth a look anyway. It felt exactly like it was running out of gas with a full tank. don't remember if the prime would come on or not. just something to look into. 1/11/2008 4:46:34 PM |
JBaz All American 16764 Posts user info edit post |
Is it stunt ready and never have been stunted before? 1/11/2008 5:14:53 PM |
toyotafj40s All American 8649 Posts user info edit post |
Quote : | "Is it stunt ready and never have been stunted before?" |
sure.
I will try to mess with it this weekend. right now it hasnt acted up again. i dunno if that's the issue. bc if the fuel pump was getting power, and not working as was tested out when we had it apart im guessin the ground would be working. bc we would plug it back up and it wouldnt work (fuel pump wouldnt prime, even tho it had power).
i dont know much about anything tho.
[Edited on January 11, 2008 at 6:44 PM. Reason : .]1/11/2008 6:42:57 PM |
toyotafj40s All American 8649 Posts user info edit post |
turns out it's a wire on my main harness right near the left ram air cover that has a wire that was clipped out. depending upon how you position the remaining wire.. it will let the fuel pump prime or not.
weird.
im guessing it's the bank sensor that was removed by just clipping it out? 1/13/2008 9:26:26 AM |
Squirt All American 5656 Posts user info edit post |
Quote : | "this is not that one race f4i bike it was CL was it?]" |
I swear... you and your pieces of shit... But the way you drink and ride and treat your trash toys I think a beat up POS is good for you unless you enjoy tearing them up and pissin' more money to fix them... bwhahahahahahah1/14/2008 8:22:39 AM |
toyotafj40s All American 8649 Posts user info edit post |
wiring harness soldered, hot glued, and repaired. 1/14/2008 9:09:38 AM |