yeah, i did that to the Ultra 150 about a week ago.

might actually take it for a ride today. either that, or rent a Cessna.

or maybe both.

2/20/2007 7:47:28 AM

69 and i finished up the onboard air install on sunday. should be pretty sweet runnin air tools off of the jeep

2/20/2007 2:38:32 PM

I got bored yesterday and kept getting sick of looking at my garage refrigerator with all the rust spots on the front so I spent all of last night sanding it down and primered it flat black. same paint job as squirts buell and my f2 :p

2/26/2007 2:42:32 PM

washed Evo

adjusted throttle on Ultra 150

cleaned surface to reattach non-slip rubber mats on left side of hull. bought adhesive. didn't quite get around to finishing it today, though...maybe do it tonight, then run it tomorrow afternoon and see if i get any more speed with the readjusted throttle.

2/26/2007 6:46:43 PM

new 02 sensors, new tranny fluid, and rotated the tires on the 540.

last weekened finished up all the seats/harnesses in the E30

2/26/2007 9:58:03 PM

grooved 2 and a half of my 4 tsl's. been workin over the weekend on the tj also. new bushing in all of my lower control arms, new front uppers, rebuilt all of my cartridge joints, installed tera 2 lo in my tcase, and i've been fabbing up my flat skid/crossmember also. still have a lot to do, but it's coming along

3/16/2007 1:26:32 PM

I changed the leaf spring hangers on my truck today broke 3 wrench and one half inch drive rachet. but they look pretty!

3/22/2007 6:30:23 PM

Replaced my bilsteins on the tacoma. Macpherson struts are the bane of my existence. Oh, and I got PB Blaster in my eye, FTW!!!!

3/22/2007 8:03:19 PM

^ who the fuck are you?

replaced batt. cables, batt holddown with duct tape now

3/22/2007 8:20:49 PM

what do you mean?

3/22/2007 8:22:11 PM

i think he is pook We going to the rock show wid the 4 runna or what im down for throwing cash for a trailer incase ol girl dont fair to well

3/22/2007 8:22:58 PM

Night before last I finally vacuum bagged this composite delta wing I'm making for a friend. Cool materials to work with but damn if it isn't time-consuming. This one took 4 evenings (and a LOT of mess) so far.

3/25/2007 10:21:42 AM

well so far in the past few days me, 69, and zxappeal have drilled/countersunk holes in my 1/4" skid plate, adjusted rear uppers and set the pinion angle, filled tranny/tcase with fluid, cut/shortened/bent tranny shifter so i don't hit my hand on the dash, bolted in the xmember, bolted up driveshaft, all four 3.5" coils replaced with 2.5" coils. that should be about it. going to pull the skid, paint it, adjust track bars, bolt coil retainers in, need to get the novak shifter for the tcase and install that. then it's off to do some wheelin w/ zxappeal haulin my ass there

[Edited on March 30, 2007 at 7:27 AM. Reason : psi]

3/25/2007 12:39:23 PM

recently, put oem m5 shocks on the 540i (whole new car now), and deleted the half stuck thermostat from the E30

3/25/2007 1:51:14 PM

took a messed up 2bbl off of my 68 Ford truck and put a 600 Holley on it using an adapter to the 2bbl intake. it's running good, but the pickup tube in the gas tank is stopped up. good thing it's behind the seat and easy to get to. hopefully I'll get it back on the road before long.

3/25/2007 9:14:31 PM

finished the flat skid and drove the jeep today 3 more things need to be done and then it's wheelin time

3/25/2007 9:26:44 PM

threw my trail tsl's on, had to replace upper and lower balljoints on my passenger side, unexpectedly and that's ab it, should be putting my tcase shifter on tomorrow, front d-shaft, console back in, etc. then load it up and off to callalantee, i'm pumped!

3/29/2007 11:48:07 PM

Trying to sort through this nigger wiring on my truck.

Never buy a truck from a Puerto Rican who bashes niggers.

Ironically, he's niggered up more shit on this truck than you could imagine.

3/29/2007 11:53:04 PM

replaced the wipers and put some gas in the car, then proceded to take a 3 hr nap

3/31/2007 7:45:08 PM

redid my on board air system. should be pretty bulletproof now

5/18/2007 5:37:40 PM

wired up trailer harness on the E30 for the tire trailer.

finished off sunroof delete

painted bumpers and grill (i love bumper coating, looks great)

painted new track wheels (yes, i'm so fagg0ty i painted my track wheels)

spiffed up tire trailer

swapped back to street pads for autox tomorrow

The E30 is getting close to being wrapped up. last issue i want to address is getting a new steering wheel and moving it closer to me and squaring away the seating position. Then thats it till cage time next year. I'll post some pics later.

5/19/2007 11:49:29 PM

Lately I bought an 89 Grand Marquis and charged up the AC, replaced the steering sector, and adjusted the TV cable on the transmission, which I am going to have to replace. It's ok though, I got the car and a good trans. really cheap.

5/20/2007 11:31:03 AM

bttt

12/17/2007 10:30:30 PM

cleaned about 50lb of ice

12/17/2007 10:38:20 PM

finished my new bumper, pics to come

12/17/2007 11:02:27 PM

did a master cylinder and bled the brakes on the superdodge

12/19/2007 7:15:24 PM

cleaned the injector pump strainer and check valve on our Case forklift

12/19/2007 8:09:14 PM

installed data and phone to a new part of building T. setup equipment and trouble shot down phones with a coworker in building n. then celebrated some dudes retirement .

12/19/2007 8:28:12 PM

^ i thought they had mexicants to do that shit, they'd probably fuck up less

12/19/2007 9:30:10 PM

Yesterday removed and installed an ABS pump/computer on a Z3, air control valve on some other car, can't remember, also did a power steering pump on another car.

Today, changed differential fluid in front and rear of an X5, tune up, and also oil change. Almost fucked up when I forgot to tighten the cap to the drop in oil filter, but luckily Nick remembered and asked me if I did.

Overall, I learned a lot more yesterday and felt much more useful then than I did today.

12/19/2007 9:40:52 PM

Quote :

"^ i thought they had mexicants to do that shit, they'd probably fuck up less"

12/19/2007 9:45:01 PM

terminated a transmission line


yay 50 ohm resistor placement. what an overhyped career hw engineer is

12/19/2007 9:48:22 PM

I'll be putting one of these



on this



hopefully in about a week.

12/20/2007 9:00:54 AM

bttt per request

4/24/2008 5:20:14 PM

not today but last weekend my day and i replaced the hood, radiator, radiator support, and bumper cover for where some woman stopped short at a yield sign...my car when right under her

it was a bitch drilling out all the spot welds on the radiator support, maybe 50 of those things

got it done in about 8 hours or so

4/24/2008 5:28:27 PM

neglected maintenance to get big red ready for some serious miles, transmission filter and fluid, and solenoids, spider gears, sway bar end links, new rim for my spare, and a good checking over

doors on slravene's yota, cut out the floor and fenders, and a transfer case in Jeepman's jeep

4/24/2008 11:22:53 PM

turbo (downpipe) back 4" MBRP exhaust







[Edited on April 24, 2008 at 11:28 PM. Reason : ]

4/24/2008 11:26:31 PM

washed big red and dad's bike and took it out for a floggin

4/27/2008 6:29:39 PM

gonna change the engine and lower unit oil in the boat today, along with replacing the bilge pump and fixing the relciner on the drivers seat, and a new battery and spark plugs for the sea doo

5/24/2008 7:31:18 AM

timing belt job on integra.

twas good

5/25/2008 11:57:31 PM

final track day prep for the E30. This is our last event together. she's for sale cuz i'm moving.

5/27/2008 1:05:27 PM

installed new rotors all around on the Evo.

http://www.dba.com.au/2006/products_4000.asp

6x6 wiper slotted. Really happy with them so far.



[Edited on May 27, 2008 at 1:17 PM. Reason : .]

5/27/2008 1:14:05 PM

i r chiken strips

5/27/2008 1:20:31 PM

added some more gussets to the cage. gotta get up with colter to put a bend in one tube and i can finish up the X

5/27/2008 1:20:57 PM

^^^are you using outgassing track pads from '85?

5/27/2008 1:22:51 PM

I switch between Hawk HPS and HP+. Depending on if I have a track event or not (which I haven't in a while but will start back up this summer)

5/27/2008 1:23:38 PM

finished the x for the cage and added two additional supports between the b and c pillars

thanks colter for helping get that one tube bent

7/3/2008 10:44:58 PM

c5- put some gas in. embarrassed an annoying cobra.

i think i might put in my fancy $10 hid wanna be headlight bulbs on the passenger side tomorrow if i get around to it. it's been a few weeks since i did the driver side. don't want them to get all out of whack in their failure times and all, and the one blue/one yellow novelty has sort of worn off. i'm also highly considering spraying one of the front rotors with a lubricant of some sort. maybe pam. works well in the oven and brakes get hot. the occasional squeal under hot stopping is getting annoying. of course none of this will interfere with a quick run to the sc line for a trunk full of illegal fireworks, though....

7/4/2008 1:23:30 AM

I put some air in my tires.

7/4/2008 1:25:38 AM

Quote :

"of course none of this will interfere with a quick run to the sc line for a trunk full of illegal fireworks, though...."

jenn says that NCSHP has threatened to be doing border checkpoints at the state line looking for such contraband BUT should you manage to acquire some of said merchandise, bring them to my place and we can blow em up

7/4/2008 3:30:09 AM