xvang All American 3468 Posts user info edit post |
Seems like my battery won't hold a charge. I was gone for a whole week on vacation this past week and it seems like my battery drained out on me. It's probably because I improperly installed a toggle switch for my intercooler sprayer (n00b)...
Anyways, my questions are:
1) Is my battery still good after being drained like that? So far, it doesn't seem like it wants to hold a charge for that long. Even after jumping it and driving for a few miles.
2) How long does it take to fully recharge a drained battery?
3) What's a correct way to send power to a toggle switch then to a pump? I just connected it straight to the (+) battery with a fuse. I did that because I was lazy and couldn't find any other spot to connect it to.
[Edited on July 7, 2006 at 9:58 AM. Reason : never mess with anything electrical on your car ever again xam] 7/7/2006 9:42:14 AM |
xvang All American 3468 Posts user info edit post |
Updated info:
Also, when you start the car, all the dash lights flicker along with a rapid clicking noise, and the battery goes dead. I figured this was probably due to a bad connection somewhere. So I disconnected the sprayer and related electrical connections (i.e. pump, ground wires, etc...) 7/7/2006 11:03:13 AM |
Grapehead All American 19676 Posts user info edit post |
sounds like your battery has given up the ghost. not holding enough charge.
try another one. 7/7/2006 11:31:17 AM |
Mike A New Recruit 24 Posts user info edit post |
If a battery is completely dead (starter won't crank, lights won't go on,etc.), you really need to let it charge overnight with a battery charger. Car batteries hold an unbelievable amount of juice, and naturally need a good time to fully charge.
Also, batteries are usually good for about 5 years. Anything after that is usually fair game. Is it older than that? I'm not saying that 5 years is the threshold. I've seen them crap out after 3 years, and also my grandpa's 98 town car is still on it's original battery. The point: If it's an old battery it could have just crapped out on you. They don't hold a charge when they do. 7/7/2006 12:21:20 PM |
69 Suspended 15861 Posts user info edit post |
the older it is, the less likely it is to recover from a full discharge, it will build up too much lead sulfate in the bottom 7/7/2006 12:32:43 PM |
xvang All American 3468 Posts user info edit post |
2004 ... so it's fairly new still. I'll just jump it again and drive it around tonight for a good while... go cruising or something. If it still has problems starting tomorrow morning then I guess I'll have to go buy a new one. 7/7/2006 12:53:06 PM |
69 Suspended 15861 Posts user info edit post |
you still havent said what make, model, engine is in the car, that would help with the wiring 7/7/2006 6:04:46 PM |
zxappeal All American 26824 Posts user info edit post |
Methinks it would be a good idea to charge the battery with a charger, especially if it's a GM of sorts with that goddamn CS series alternator.
Good way to kill your alternator too...jumping it and driving around and hoping to charge the battery like that. 7/7/2006 6:06:36 PM |
xvang All American 3468 Posts user info edit post |
Took battery to AutoZone this afternoon... the test showed: Bad Battery
It wasn't holding it's charge. Stupid OEM batteries... Anyways, I went ahead and bought one of the high-end AutoZone batteries. I hope it works out. For now, I disconnected my intercooler sprayer. I'll try hooking it up again this weekend.
Maybe I had a bad grounding point? I grounded the switch to the same point as the negative side of the battery. Ground is ground, right? 7/7/2006 6:29:37 PM |
underPSI tillerman 14085 Posts user info edit post |
the real question is: how do you improperly install a toggle switch? 7/8/2006 2:37:35 PM |
arghx Deucefest '04 7584 Posts user info edit post |
Quote : | "Good way to kill your alternator too...jumping it and driving around and hoping to charge the battery like that." |
yeah be really careful. I fucked up my alternator that way.7/9/2006 10:57:37 PM |
xvang All American 3468 Posts user info edit post |
Quote : | "the real question is: how do you improperly install a toggle switch?" |
... maybe there is a better way than how I did it? Just atskin' ...7/10/2006 12:58:14 AM |
69 Suspended 15861 Posts user info edit post |
still havent said what kind of car it is 7/10/2006 10:00:40 AM |
xvang All American 3468 Posts user info edit post |
[Edited on July 10, 2006 at 3:12 PM. Reason : pic]
7/10/2006 3:11:38 PM |
tchenku midshipman 18586 Posts user info edit post |
if the IC spray pump takes some POWR (fog lights, etc), then you should run it off of a relay instead of straight from the battery. I'd throw a 30amp fuse or something between the (+)battery and relay
just like this:
86: ground 85: +12V from a switch 87: to IC pump (+) 30: +12V from battery
So basically when you close the first circuit, the 2nd one lets the +12V flow 7/11/2006 1:33:45 PM |
xvang All American 3468 Posts user info edit post |
^ Sweet, thanks... i'll try that this weekend. 7/11/2006 1:51:10 PM |
arghx Deucefest '04 7584 Posts user info edit post |
Do yourself a favor and don't get a radioshack relay. I've had them blow out on me severak tunes. Granted, I was running a 20+ amp air pump. I've got a Bosch universal one now with the 4 terminals and it hasn't given me problems so far. 7/11/2006 3:49:53 PM |
xvang All American 3468 Posts user info edit post |
Haha, thanks for the heads up. I was about to go to radio shack this afternoon...where's a good place to get one then? Where'd you get your bosch one? (either online or locally) 7/11/2006 3:56:49 PM |
zxappeal All American 26824 Posts user info edit post |
Either that or get you a Standard Motor Products RY115 or RY116. Available at Carquest. 7/11/2006 3:57:13 PM |
tchenku midshipman 18586 Posts user info edit post |
walmart relays have never failed me 7/11/2006 9:31:06 PM |